Farmall & IHC Tractors Discussion Board |
Re: Farmall A gaskets
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Georgia Boy on September 09, 2004 at 19:16:51 from (68.117.209.109):
In Reply to: Farmall A gaskets posted by Wayne M Kittler on September 09, 2004 at 16:45:22:
Well, it"s not too difficult, but it is time consuming. I am restoring a 46 A right now and decided to take everything apart, clean out the old oil and grease, replace any bearings that were bad, and replace all oil seals and gaskets. I have now gotten the rear end put back together, but since I stripped the paint and sand blasted the cast parts while they were off, it"s hard to tell how much time it is taking (forever it seems). The A is a small tractor and pretty light, so horsing the parts about is much easier than the bigger tractors. That saves time. By the way, you can't do it without a shop manual and a parts manual.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|