Farmall & IHC Tractors Discussion Board |
Re: Farmall Super C for mowing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on July 19, 2004 at 05:59:20 from (12.65.18.237):
In Reply to: Farmall Super C for mowing posted by Maine-ah on July 19, 2004 at 05:38:57:
The Super C should handle a 5 ft bush hog OK. You will need and over running clutch for the PTO so the bush hog inertia won't push you when you want to stop forward motion. You can get a 3 point conversion for the Super C from Saginaw County Tractor. If you don't have a hydraulic remote, you will have to add that to work the cylinder for the 3 point. Worksaver makes a 3 point conversion that works off the rockshaft arms. However the rockshaft arms are not strong enought to lift much on the 3 point and the arms that pass from the rockshafts to the back are in the way. You can get a finish mower from Woods. You can get a belly mower or one that goes on the 3 point hitch. All this "stuff" is going to cost you quite a bit more than you probably will have to pay for a fairly decent Super C.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|