Farmall & IHC Tractors Discussion Board |
Re: 684 PTO slipping
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by agmantoo on July 11, 2004 at 16:30:58 from (206.228.212.149):
In Reply to: 684 PTO slipping posted by Danny P on July 11, 2004 at 13:24:39:
Your suspicions are correct that the clutch to the PTO is out. The clutch is more a clutch pack than a conventional clutch. I have replaced 2 in a 574 and it is not too bad of a task. You do not have to disassemble the tractor as the clutch pack can be accesssed thru the cover plate after removing the fluid. The pto shaft is removed from the rear , another rather easy task. The hardest part of the task due to working in a tight space and poor light is extracting a dowel type pin. If I were to do another replacement I would make myself a drop light using a 12 bulb from a car and a light socket requiring 2 wires. These 2 wires would be connected one to ground and the other to the hot and then I would insert the light into the housing to where I could see a lot better. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|