Farmall & IHC Tractors Discussion Board |
International 404 not pumping after filter change
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on June 25, 2004 at 13:20:06 from (69.170.212.224):
I recently bought a '62 IH 404. The hydraulics (steering and 3 pt. lift) seemed a little slow to respond after starting, but then worked fine. The day after I used the tractor for the first time (light brush-hogging), the hydraulics seemed to respond even slower than originally, but then again, once working, worked fine. I assumed it needed a filter change so thats what I did. Now I have NO hydraulics! I was told that the pump probably lost its prime and to drive the front end into a ditch. This had no effect. Does anyone have any ideas? Is there a screen or anything between the trans and the hydraulic system that could have become clogged and not allow fluid back to the pump? When I check the hydraulic level in the rear, it's now overfilled which makes it seem that it's not allowing it to circulate back to the pump. Any help would be GREATLY appreciated!!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|