Farmall & IHC Tractors Discussion Board |
Re: Radiator gasket sealer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kfox on June 04, 2004 at 21:10:30 from (67.241.33.161):
In Reply to: Radiator gasket sealer posted by Mike on June 02, 2004 at 19:36:11:
What kind of gaskets are you using Mike? I rebuilt a few F-20 radiators several years ago and I used cork gaskets and old fashioned gasket shelac. I couldn't get cork gasket material long enough to make one piece gaskets, so I just cut joints at a forty-five angle. Made the bolt holes a bit small, and everything a close fit. Also, do you have the sheet metal pieces with the bolt holes in them that go on the outside of the flanges? The cork seemed to be thick enough to compress some when the sides were bolted on the top & bottom tanks. Hope you have good luck with your 20. Ken
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|