Farmall & IHC Tractors Discussion Board |
Re: Loader for an M, 450
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jed on April 12, 2004 at 06:52:46 from (66.212.143.210):
In Reply to: Loader for an M, 450 posted by Franklin in NC on April 10, 2004 at 18:43:13:
A loader off of an M will fit an H Farmall, because the wheel base is the same. The 400/450/300/350 is longer because of the TA, exactly 9 inches longer. Depending on which loader it is, there may be enough clearance out front. If not you would have to shim up the rear of the loader, where it mounts to the axels. An M loader would fit a lot of the JD tractors;A/B/60/50/70, because the wheel base lenghth is the same or real close. A John Deere 45 loader makes a nice loader on an M or an H. In regards to other tractors and fitting to them, the wheel base length and the shape the rear axel, round or square, will determine if it could be done. With a shorter wheel base you would simply have to shorten the loader.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|