Farmall & IHC Tractors Discussion Board |
Re: Re: Re: will this work from M to H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by zak on April 07, 2004 at 07:48:05 from (128.175.85.99):
In Reply to: Re: Re: will this work from M to H posted by chad on April 07, 2004 at 06:47:58:
Chad, I've done this swap on my 300 (using a 400 WFE). The bolt holes are spaced 4 1/2" on center, square. Additionally, they are 3/4" holes for the M, while the H, 300, 350 uses 5/8" bolts. The frame rails are 18" across on the H, 300, 350 (If I recall correctly) and 20" on the larger series. You'll have to make a new rear bracket which is less difficult than it sounds if you have some plate stock lying around. The front pedestal mount can either be notched to accomodate the smaller bolt pattern, or you can cut the whole plate off your WFE and just weld a new one on (Which is what I did). The plate is easy enough to make. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|