Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 Tool Box
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 29, 2004 at 04:15:37 from (209.226.247.106):
In Reply to: Farmall 300 Tool Box posted by Brian Schmidt on January 28, 2004 at 13:23:53:
Brian: My 300 had one with no cover. My dad bought the tractor new so I know it was factory. About 12" long, 7" wide and 4" deep. I always wished it was about 3" longer so larger wrenches would fit right in. Over the years wrenches larger than 15/16 had to lay with one end up on edge. There was room to make it longer even with the belt pulley. I know we planted more than one 1-1/8" wrench over the years. I built one for my 560 and made it about 20" long as the 560 didn't have a belt pulley. To the unknowing eye it looked just as much factory as the box on the 300. As one of the earlier poster said box just used tabs welded to it for mounting to bolts already in the casting of the torque tube.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|