Farmall & IHC Tractors Discussion Board |
How to remove 484 exhaust manifold? (picture)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by clanger on January 22, 2004 at 10:12:14 from (80.176.149.33):
I've just started stripping my 484 (D179 engine) down in order to replace the sleeves/pistons this weekend. I've come to remove the exhaust manifold and 5 of the six nuts/studs came out easily, but the top middle nut is very difficult to get to. The problem is that there is another manifold between the exhaust manifold and the cylinder head (which seems to be where the cooling water enters/exits the head). I can get 3 of the 4 bolts off this, but again the last one is VERY difficult to get to. So I'm a bit stuck. Any ideas? I could simply cut the top hose off and leave the exhaust manifold on, but that may not be the best way to go.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|