Farmall & IHC Tractors Discussion Board |
How to install a voltmeter
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave in CT on December 21, 2003 at 09:46:38 from (64.252.221.6):
I have a single wire 12V neg ground conversion on my 1947 H. I've heard that a voltmeter can be more useful for monitoring charging/electrical systems but, not wanting to blow up my voltmeter, I need to walk through the procedure step-by-step. I read one post that said (paraphrased) hook the + post on the voltmeter to the positive post on the battery and the - lead post on the voltmeter to any good ground. Make sure there's a switch in the circuit so the voltmeter doesn't run down the battery. My question is this - can I safely install the voltmeter by running a lead from the shut-off switch (the side that has the other lead that runs to the coil) to the + post on the voltmeter and run another lead from the - post on the voltmeter to a good ground? This way, the shut off switch takes care of the battery run-down. Thanks, Dave
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|