Farmall & IHC Tractors Discussion Board |
Re: Took out pistons on cub......what do i need to
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RN on December 18, 2003 at 19:07:51 from (166.126.218.251):
In Reply to: Took out pistons on cub......what do i need to buy posted by Tyler on December 17, 2003 at 17:22:29:
Re Cub: Engine didn't come with sleeves, .010 inch honed over can maybe knurl piston skirt and new rings. slightly oversize 'service' rings if available best for use then. Cub piston sets with rings available .020 to .040 oversize advertised-need bore and hone job. Flathead engine, check valve seat area in block for cracks. As other stated check crankshaft and bearing area. Also check oil pump and oil channels. Head check- cracks and warped? RN.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|