Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Will a 806 wfe fit a Farmall M?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GP on December 09, 2003 at 14:02:35 from (167.68.1.65):
In Reply to: Re: Re: Will a 806 wfe fit a Farmall M? posted by Matt on December 09, 2003 at 11:48:43:
Yep, wide front from an 806 Farmall would bolt right up. I think there may be differences in the wide front of a International (standard/wheatland) vs a Farmall, but I am not certain. I don't think IH ever made an 806 utility (just 606 and 656). The 666 WF will not bolt right up, you will need to drill holes for the rear support bracket (this may or may not be possible depending on location of the engine mounts). I have no use for the high clear WF, was just thinking if you were close by I could sell you my 656 row crop WF and buy the 666 WF, but KY is too far away for that to be convenient.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|