Farmall & IHC Tractors Discussion Board |
Re: Firing off an M.D
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on December 08, 2003 at 07:50:03 from (68.188.227.110):
In Reply to: Firing off an M.D posted by John on December 07, 2003 at 21:28:39:
John, WE had a 48 MD also, and the protocal we used was: (1) Switchover handle foreward, throttle off. (2) Start on gas and let run for approximately one minute, longer if below freezing. (3) After gas warmup, give quarter to half throttle. (4) Pull switchover handle back. (Note: No more than one second should elapse from throttling sequence and switching from gas to diesel) There may be a more proper way, but this always worked for us. While on the subject, we always idled down on diesel, then switched back to gas with throttle off and let idle for approximately 15 seconds then pulled back switchover handle with throttle completely off to shut off tractor. This was to create a cool down period before shuting down completely. I know some people just cooled down on diesel, and didn't switch to gas before shutting down. I really don't know which is correct, or if there is a correct way other than making sure the tractor isnt shut off immediately without a cooldown. This prevents cracking the head.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|