Farmall & IHC Tractors Discussion Board |
Re: ih 240 utility steers hard with loader on
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B. on October 18, 2003 at 14:43:22 from (209.163.30.18):
In Reply to: ih 240 utility steers hard with loader on posted by deano on October 18, 2003 at 06:43:31:
The engine driven hydraulic pump is the only pump on the 240. If the Fast-Hitch and the remote valves have good lifting power, the pump is most likely fine. The problem could be in the regulator/saftey valve. I'm more familiar with this valve on non-power steering 240's, I'll have to check my book and get back to you. Have you checked the screen and changed the filter? They're located under a square cover held on by four bolts at the base of the hydraulic valve support on the right side of the tractor. Also, I would strongly reccomend that you don't put a loader on that 240. I've heard of too many of these tractors in the Farmall C- 240 family breaking in half when a loader is used. Sheetmetal parts for a 240, especially the side panels, are just about impossible to find.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|