Farmall & IHC Tractors Discussion Board |
Re: F-30 tires
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JohnG(TX) on August 11, 2003 at 10:57:58 from (216.136.20.34):
In Reply to: F-30 tires posted by howster mighty fine on August 08, 2003 at 18:07:47:
There is a conversion which can be done to raise the front end about 3". It does involve adding a 3" section to the lower part of the steering shaft and slipping a 3" spacer over the shaft. This raises the front end up and the lower bolster bearing rests on the top of the spacer. I have a Regular with this conversion, and have seen many others done like it. I have a friend who did it recently with great sucess. It was done when the steels were replaced by rubber. I don't know if it was a 'Dealer' item, or just any garage was doing it. I did not find any mention of it in the parts books and have no idea what happened when IHC sold a tractor with rubber from the factory. You can do the conversion, but it will modify the tractor. Have you considered sticking with steels? JG
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|