Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Question for Hugh MacK
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 28, 2003 at 01:59:28 from (216.208.58.169):
In Reply to: Re: Re: Re: Re: Re: Re: Question for Hugh MacKay posted by Red Rider on July 27, 2003 at 21:47:13:
Red: I am going through the section called condenced service data. I will quote you differences where there are differences. Bore C-123, 3-1/8 and C-135, 3-1/4. Stroke C-123, 4" and C-135, 4-1/16 Compression ratio C-123, in 100,200,130 and 230 - 6.5-1, C-123 in 140 and 240 is 6.8-1 and C-135 in 404 and 2404 is 7.4-1. Valves intake are all .014, exhaust .014 on all but C-135 in 404 and 2404 where exhaust setting is .020 I do see some differences in carburator, and I suspect this is more age than size of engine. It shows C-123 engines as having Carter Carb with 17/64 float setting or Zenith Carb with 1-5/32 float setting It shows the C-135 engine with Marvel Schebler with float setting of 1/4.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|