Farmall & IHC Tractors Discussion Board |
806 finishes for green AGAIN
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KX on July 20, 2003 at 14:50:16 from (216.40.222.152):
Well yesterday and today I had the pleasure of bailing hay with my 806 for a green 2840 that broke (hyd pump). Earlier this year on the first cutting, another neighbors green 3040 laid down (hyd clutch cylinder) in the middle of bailing and the old 806 finished that job as well. I ate a lot of chaffe and dust the last couple of days in 100+ heat but I now have two neighbors to rib about how when the going gets tough the tough gets going and the jd's hide. Well see who breaks on the third cutting but the 806 will be ready to roll if needed. One month till plowing for winter wheat!
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|