Farmall & IHC Tractors Discussion Board |
Amp Gauge Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary_N_WV on June 09, 2003 at 07:35:12 from (129.71.234.254):
In a catalog I have, there is an amp gauge listed for Super H, M. Another gauge is also listed for the Farmall F. I have a 9n ford that has a univeral gauge installed in it,which needs replaced.... but since the charge rate is normally low, I'd like to get something with a little less amperage for full deflection....to make it easier to see what it's charging. The above mentioned gauges are 20-0-20 instead of 30-0-30.... Can anyone tell me about the way they mount?...Will they work in the 2 inch hole the universal is in now?..... I've never seen one of the gauges but don't think there is any reason it couldn't be adapted.... Is there some special quirk to these gauges that might hinder installing one????? Thanks !
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|