Farmall & IHC Tractors Discussion Board |
TA noise
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CityFarmer on April 01, 2003 at 09:54:02 from (66.222.121.38):
I have a noise coming from the TA on a 756 Farmall. The noise (sounds like metal hitting metal) will stop when I push the little butterfly forward (the one that is moved forward when the clutch is pushed in). Do you think this noise would be from a bearing or gears. I have never worked on a TA and I am wondering what I am getting myself in for. I do not have a service manual on the TA nor do I have an exploded view of it. Is there either on the net some where. The HI and LO TA work just fine other than this clanking noise. Also wondering if I could just keep this butterfly pushed forward until I get a chance to fix the problem. What would the effect of this be. Thanks John Pawlicki
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|