Farmall & IHC Tractors Discussion Board |
Distributor / Tach gauge
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike on August 04, 2002 at 17:31:41 from (12.216.50.95):
I put a new temp gauge on the 460 yesterday and was looking at the tach gauge to see what it needs to work. No cable. However it wouldn't fit anyway. The distributor is in at a goofy angle. It is turned so the cable would come out right into the block, don't think it would fit. Apparently somebody tinkered with this old girl and put it in turned. Doesn't this mess up the fire order or the timing or something? I always thought they had to go in at the same way they came out. Could be they corrected it with the timing or something. Tractor runs good. I don't know squat about distributors, can it be pulled and put in with the correct angle? From pictures it looks like the cable and gears should come right out parallel to the engine and it makes a straight shot to the dash. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|