Farmall & IHC Tractors Discussion Board |
M with a variable miss
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BTD on June 18, 2002 at 08:16:07 from (198.36.89.12):
My '44 M is tasking my knowledge on what to do to make her run smooth. She has for some time been running with a not too regular popping sound, seems like a backfire since it gives me a good 'klang!' from the weather cap on the muffler. So far I have put on new steel core wires, Champ. D21 plugs (she gets fairly light duty), a new coil, and ran some fuel system cleaner through her. I have also done a lot of fiddleing with the carb and adjusted the valves to .020 cold clearance. Nothing seems to help. It is time to bit the bullet and pull the head to get a direct view of what is going on? I've thought about the cap and rotor, but wouldn't a problem there make a regular miss instead of whenever miss? I've never put a head back on after pulling it so this is territory I'd rather not travel unless totally necessary. I'm rebuilding an H and had intended that engine to be my classroom on head, headgasket, and torque. Thanks for any and all info! -BTD
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|