Farmall & IHC Tractors Discussion Board |
Update #2: Help on loosening Exhaust Manifold Bolts!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dvtw on May 06, 2002 at 06:40:42 from (136.205.16.3):
Saturday I began work yet again on trying to get the exhaust and consequently the intake manifold (since they are attached and held on by the same bolts) off of the 560. As of Saturday morning I still had 4 stubborn bolts to get out. I picked up some PB Blaster Friday just to complement the liquid wrench and a set of 6 point wrenches to use instead of the 12 point I had been using which had started rounding off the bolt heads. The 6 points were definitely worth the money (plus they were on sale!). I gave them another good dousing Friday night this time with the PB and then first thing when I got out there Saturday morning to work on them. After about an hour and a half of hammering, punching, tugging and a pipe on the end of the wrench I got three of the 4 out with no problems. I was elated, now only one to go...to make a long story short, the final bolt with the most misshapen head broke off. I got the manifolds off but I still have a stud sticking out. I don't have a welder to weld the nut on like I've heard to do. I started using the vice grips, heat, occaisional punch with the hammer and more PB but the vice grips keep slipping! It's still in the head. I'm thinking of cutting it off and then drilling it out. If I drill it just a little shy of the diameter of the bolt will the remainder just fall out? What size bit should I use? The bolt is 3/8". Thanks again for all the advice!
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|