Farmall & IHC Tractors Discussion Board |
Head Gasket Replacement on Super A
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hartford in Beeton on May 10, 2007 at 17:53:57 from (216.209.20.141):
Jim, OK, now you have me worried. The only oblong (odd)holes are one at each end of the head. The rest of the holes are round. I do not have a water pump. The part number for the head gasket I purchased is 366300R3, which is the same as the one removed from motor when head was removed. Is the correct one? Pistons are 3.25 inches in diameter. Thanks, Hartford Hi Everyone, This is a rookie question. Does "This side out" on the head gasket mean "this side up" or "this side towards head"? Are most of you using NAPA copper spray on gasket to help with seal (I am using CASE-IH head gasket)? Thanks. Jim Becker Make sure you have the right gasket. With no water pump, you should have the larger (odd shaped) water passages in the gasket.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|