Farmall & IHC Tractors Discussion Board |
Re: M Two Way Hydraulic Leak
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on April 24, 2007 at 05:54:11 from (64.80.108.53):
In Reply to: Re: M Two Way Hydraulic Leak posted by AKB on April 23, 2007 at 19:54:52:
Get a 2 gallon vented steel hydraulic tank. Mount it under the gas tank in a convenient location with the vent on top. Make sure you can get to it easily to check the level and fill. Disconnect the line from the OUT on your two-way valve to the fill pipe on the belly pump. Remove all extra fittings from the fill pipe. Run a line from the lowest bung on the tank directly into the fill pipe of the belly pump. No vents, no tees in this line. The venting is done by the auxiliary reservoir. Connect the OUT line from your two-way valve into another low bung on the external tank. Now the oil flows from the external tank, into the belly pump reservoir, through the pump, into the valve, and back into the external tank.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|