Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 spark plug wires
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on March 23, 2007 at 06:37:26 from (199.17.6.122):
In Reply to: Farmall 300 spark plug wires posted by Lupe Rodriguez on March 22, 2007 at 18:47:55:
if it is normal, it is: 2-1 4-3 looking from the rear of the tractor. #1 is front cylinder. The issue is that the engine will run correctly and be in time in a number of positions if assembled differently. so the real info (If the dist has not been pulled out) is to turn the engine with #1 spark plug out, and your thumb, or a round end fat stick in the sparkplug hole, until compression pressure blows air out. Then grank further very slowly to get the piston to the vry top. (the timing marks on the front pulley will then align) now you know for sure which is #1 on the Dist cap. JimN
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|