Farmall & IHC Tractors Discussion Board |
Re: Roosa-Master pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on March 22, 2007 at 19:09:11 from (66.188.221.148):
In Reply to: Roosa-Master pump posted by georgeky on March 22, 2007 at 14:42:53:
George, I've seen your last few posts about fuel leaking around the thottle shaft. My advice to you- grab the wrenches and tear into it! These are not difficult at all to replace the o-rings on. I'm not familiar with the Continental diesel in your 350, but on most engines, you can replace those o-rings without even removing the pump. Just pay close attention and make note of how things come apart. If a guy wants to turn up his fuel delivery below rated speed for more lugging power, he must remove the same parts that you're going to have to so he can get at the leaf spring adjusting screw. Think how many of these have been tweeked by the average guy out under the shade tree, if they can get it back together so can you. The last thing I'd do is replace a known good pump with one from a junk tractor.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|