Farmall & IHC Tractors Discussion Board |
Injection pump question for someone who is an expe
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Spanna Monkey on March 19, 2007 at 15:51:58 from (86.134.8.118):
Tractor is an IH 784 Have recently renewed the "O" rings in the 2 dials that control fuel cut off, and acceleration on the front of the pump. (looking at it side on) Once i managed to find the "O" rings that were the best fit, I put it all back. The pump doen"t let any fuel from the four injector outlets now, and it def did the day before. It"s all bled, new filter, pump is turning, shut off valve wasn"t moved when re-assembled. (allthough did then move a lot just to get something to happen). One more thing to add is that i used an impact driver to undo the screws securing the plate that held the dials. This is a handheld thing, not air impact driver! and only needed a light tap. Just to recap.......there is no fuel being injected. Why?
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|