Posted by ScottyHOMEy on March 19, 2009 at 06:15:43 from (70.105.234.113):
In Reply to: generator posted by josh watson on March 18, 2009 at 17:44:28:
John T made a remark about grounding that jumped out at me. That 4-position switch needs to be grounded through its body, i.e., where it mounts to the front of the panel and then the panel to the frame, through the box itself.
Have you painted the tractor? If so, did you paint it so thoroughly that you wound up with a poor ground for the switch? With everything mounted in place, a quick test with an ohmmeter between the male thread of the switch where it pokes out the front of the panel and a known good ground or the grounded post of your battery should show little to no resistance. Places where paint might interfere are: between the switch body and the panel/face, between the panel and the box, between the box and the stud that holds it to the steering support, and the two long screws that hold the panel/face to the box.
One of those devilish little things you could chase circles around for days.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.