Farmall & IHC Tractors Discussion Board |
Can a Super C handle a 72 finish mower. Kind of long
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob(WI) on November 21, 2001 at 06:09:03 from (209.94.172.42):
This might be a dumb question but not knowing the PTO HP of a Super C I have to ask. I have a 72" Ransomes front mount mower with a 28 hp Continental engine and 2 years ago the crank broke and cracked the block, cranks are $7oo and the block is shot, Continental claims the engine is obsolete, we already have $14oo in the Hyd. pump\drive and don't really want to spend more on a poor design so rather than scrap a rebuilt 3 blade deck I was wondering if the SC would handle the mower if I made up a mount and drive shaft\belt set up. I have a bunch of open yard I could use the high sitting SC to mow and it would be faster I think in first with the SC doing the open area then 40" wheel horse for all the yard which takes 5 to 6 hours now, think it will work??? FYI the mower would be mid mount.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|