Farmall & IHC Tractors Discussion Board |
Keeps the rust away and fills in pits
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alabama on November 07, 2001 at 19:18:50 from (152.163.197.192):
Thought I would share with ya'll how I filled my badly pitted sheet metal and will prevent it from ever rusting again. I took fiberglass resin, mixed it up and applied it to the complete grill with a brush. You will be very supprised how well it coats the pits. As a side effect, if the paint ever chips or I scratch my paint job the fiberglass will protect the metal. The finish is very smooth and thick. It dries quickly too. The only thing you have to watch is runs. It takes a bit to get used to and its kind of messy but I bet that grill will out last any of the new ones out. I did not get any brush marks either. It flows into the hard to get cracks too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|