Farmall & IHC Tractors Discussion Board |
Rebuid of TOuch Control on Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by marvin on October 13, 2001 at 21:04:04 from (63.228.98.151):
I just finished replaceing all of the seals on the hydraulic pump on the Super A. I have been losing hydraulic fluid and thought for sure it was the seal on the pump. I also see a lot of oil around the base of the touch control unit near the front of the pistons. So I am now thinking about pulling the touch control unit off of the tractor and replacing the seals. Has anyone done this lately? What should I look out for and be careful of? Want to do this right. Also the manual said that the touch control should contain 8 1/4 pints. When I drained it to rebuild the pump, I could only put about 6 1/4 pints back in. Is there about 2 pints in the bottom of the touch control unit that do not get drained out?
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|