Farmall & IHC Tractors Discussion Board |
farmall 300
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TomT on October 10, 2001 at 12:57:38 from (198.5.155.132):
I have a 300 that has no 3 pt. but does have 3 hydraulic remotes. I hate to see the old thing sit and thought it would make a good tractor to pull a v-rake and tetter with. My problem is that the remote pipes going out the rear have rusted into. It appears that these were formed into the control unit somehow. I don't even know if the pump will work and was looking for a cheap way to test.The tractor and pull type bush-hog were given to me by a friend. It was running at one time but has been sitting under my barn for a couple years now since the cows ate the wires off of it. Needs new alternator also but that will be another project. I just need to confirm that hydraulics will work and will lift v-rake to transport position. I need to justify reason for spending money on an old gas burner before I proceed.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|