Farmall & IHC Tractors Discussion Board |
Part of B Casting Broke
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Raider on February 05, 2001 at 07:45:20 from (192.105.235.146):
This weekend I tore into the '40 B in ernest. Wrastled the engine off and now I'm left with just the torque tube, axles, and final drives. The PO had repaired the casting where the brake and clutch pedal shaft mounts, and came off. I have the two pieces to the casting. Has anyone fixed this problem? I was thinking of installing an ell that could be fastened to the casting by tapping a hole. The ell would then support the remaining pieces to enclose the shaft. Would this work or is there a better way. Seems to be overkill to find a salvaged torque tube at the bone yards.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|