Update with pictures of the oliver seed discs

caterpillar guy

Well-known Member
These are the seed discs I have that are NOS discs. There are 6 of them total they have some rust from setting around in the shed but the new chamfer/bevel is on the edge of them.
 
try again
cvphoto137218.jpg


cvphoto137219.jpg


cvphoto137220.jpg

The OD is 12 3/4, Id is 3 11/16, bolts holes diameter is 4 1/2 inches with the chamfer /bevel on the edge. Some rust on them from setting around in the shed otherwise NOS discs. Total of 6 of them. Looks like a part number of M2217A .
 
That was what I had remembered about them. though I suppose a guy could weld them to the back side or cut the center out and swap the centers to make them fit. Though with the work and cost not sure it would be worth it.
 
I've got some flat ones here that could be cut out and welded back in to those, but the rivets would have to be cut off first to keep from getting the bearings too hot, then they'd have to be riveted back in. I don't know. It'd be worth a try if we knew we were going to cross paths and you brought them along I guess.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top