Had a knock in my 445 engine last winter, so today I pulled off the side panel. I think number one was a little loose, by feel so I removed the rob cap. I cannot see the part number stamping on bearing only the date of 2 56. Measured the journal and its 2.623. Being I could not see any numbers I pulled the cap off of number 4. Again no bearing numbers and the same date 2 56.
So I think this is a standard size. The question is can I only buy one bearing insert and the side inspection plate gasket? If so suggestions where I can start calling on Saturday. Thanks in advance.
So I think this is a standard size. The question is can I only buy one bearing insert and the side inspection plate gasket? If so suggestions where I can start calling on Saturday. Thanks in advance.