(800) 853-2651
SHOP NOW

70 U302 spindle

S

Scout2008

Member
Does anyone have a left front spindle for a 70 U302? The 70 spindle shaft is 14.25 inches long. Previous models were slightly shorter. They keyed end
is not splined. The weld broke at the bottom on mine, and looks like it was repaired once before. If I can?t find a good one I will try to have it welded
again. Thanks in advance for any responses.
 
Have you contacted any of the MM suppliers on www.jetstar.minneapolis-moline.com? I used to deal with Wendell Everett and Welters a lot. Their contact info is over on that other website.

I am thinking that spindle was always 2-piece. The part the wheel mounted on was bored and the vertical shaft pressed in and welded.
 
Sorry, I should have said that I have tried to traditional places I usually get parts from including Wendell and Welters.
 
Well, Wendell and Welters were my first choices. How about StaMM Sales in Kansas? In Washington KS, maybe.

After that, you may need to start calling Salvage yards, Like Baker/Abilene or Audubon tractor parts. Audubon is in IA, I don't know where Baker/Abilene is located.

MM Del would come as close to knowing where to find one as anyone on here, I would think.
 
You must log in or register to reply here.

Similar threads

I
Lilliston 7-six spindle info
Replies
0
Views
312
imatkel
I
T
Ford 960 Spindles
Replies
10
Views
1K
Timharken
T
S
Plow day yesterday
Replies
3
Views
597
CraigB.
C
C
1949 8N Battery tray, etc now that hood is off.
Replies
6
Views
1K
Tim PloughNman Daley RIP
T
Y
1974 Ford 2000, 3CYL Gas wont start
Replies
7
Views
1K
Sean in PA
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top