Youngguyoldtractors
New User
So my 3 point doesn't move.
i removed service covers and 3 point arms and that when the lower arm is pressed the pump flows hydraulic fluid.
i noticed that the position control lever isnt moving the arm very much when i go full up or down.
do i tighten these nuts to adjust or? tried moving the nuts in or out nothing really changed. is there any good manuals for these?
i have the I&T Shop Manuals and its useless basically just tells you the part names... and no specs or adjustments
set draft to middle and position to fast as i found in a video but they wont adjust properly together to move.
is there a way that im inserting the forks into the slots wrong?
This post was edited by Youngguyoldtractors on 09/21/2021 at 12:44 pm.
i removed service covers and 3 point arms and that when the lower arm is pressed the pump flows hydraulic fluid.
i noticed that the position control lever isnt moving the arm very much when i go full up or down.
do i tighten these nuts to adjust or? tried moving the nuts in or out nothing really changed. is there any good manuals for these?
i have the I&T Shop Manuals and its useless basically just tells you the part names... and no specs or adjustments
set draft to middle and position to fast as i found in a video but they wont adjust properly together to move.
is there a way that im inserting the forks into the slots wrong?
This post was edited by Youngguyoldtractors on 09/21/2021 at 12:44 pm.