kevin in oh
New User
I was wondering if anyone has ever put one on there MF35. If so did it work ok and what stand pipe would you have to use. If mine has the thinner lift cover on it.
- Thread starter kevin in oh
- Start date
miner09
Well-known Member
- Location
- Pattonville Texas
It was a improvement over the thin rock shaft.Everything will work.
kevin in oh
New User
Is everything already adjusted and ready to just bolt on?
Wow, that's more than half the price I paid for my whole machine (with the loader on it!).
You can't find a 35 or 202 (or whatever variant) in your area that's got a popped motor for cheap? They're getting scarce around my area, but if you could find one for $1000 or so, you could probably turn a profit or at the very least break even.
Ok, I'm done being cheap.
kevin in oh
New User
Id like to find a good used one cheap. But so far not
. Lol
. Lol
miner09
Well-known Member
- Location
- Pattonville Texas
Don't know about new one but if coming off a used tractor should be close. Just watch when replacing and put two control fingers in front of roller on pump.Remove side plate and watch as you lower rock shaft. New or used.
John Deere D
Well-known Member
Quote:
I was wondering if anyone has ever put one on there MF35. If so did it work ok and what stand pipe would you have to use. If mine has the thinner lift cover on it.
I have NEVER installed one of those NEW LIFT COVERS:
Have you removed your present MF 35 lift cover?
Do you own a service manual?
I had to remove my MF 35 lift cover in 2017 to replace HYD. Pump:
Bob...Owner operator MF FE 35 x and other colored Tractors:
I was wondering if anyone has ever put one on there MF35. If so did it work ok and what stand pipe would you have to use. If mine has the thinner lift cover on it.
I have NEVER installed one of those NEW LIFT COVERS:
Have you removed your present MF 35 lift cover?
Do you own a service manual?
I had to remove my MF 35 lift cover in 2017 to replace HYD. Pump:
Bob...Owner operator MF FE 35 x and other colored Tractors:
John Deere D
Well-known Member
Pictures of cover......."rigging / controls" you may have to change if you purchase a new cover with NO controls:
Bob...Owner operator MF FE 35 X and other colored Tractors:
Bob...Owner operator MF FE 35 X and other colored Tractors:
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy