reubentice
New User
I am restoring a MF65 and had to replace a power adjust rim. I was able to get the clamps off but they were impossible to adjust (after naval jelly, grinding, etc) when I went to reinstall the hub to the rim. So, i was able to install them and then reinstall onto the rails and install a locking clamp but I was only successful with getting two of the bridge shaped wedges in place. I'm not interested in adjusting the rims again, only want to ensure it wont fall off when in use. I'm thinking if I could find some sort of metal wedge, I could hammer them into where the bridge piece is supposed to take up the slack. Also, are the clamps even available as an aftermarket part? Dealer price is about $290 each!
Any help would be welcomed.
Regards,
Mark in Pittstown NJ
1959 MF65
1947 Farmall Cub
1952 TO30 Ferguson
Any help would be welcomed.
Regards,
Mark in Pittstown NJ
1959 MF65
1947 Farmall Cub
1952 TO30 Ferguson