John deere 4010

burnsg2003 · Sep 15, 2020

I have a john deere 4010 some how when I was bush hogging I seem to have twisted the pto shaft can this be replaced from the rear or will it have to be split. Any comments appreciated

SVcummins · Sep 15, 2020

Should be able to just unbolt it .

Tx Jim · Sep 16, 2020

(quoted from post at 20:39:10 09/15/20) I have a john deere 4010 some how when I was bush hogging I seem to have twisted the pto shaft can this be replaced from the rear or will it have to be split. Any comments appreciated

4010 CUT or RC?
I highly recommend to loosen cutter slip clutch if applicable or acquire/utilize correct driveline shear bolt.

4010 CUT will require a trans split.

4010 RC pto shaft repair procedure would be determined where twist is located. If twist is at stub shaft unbolt 4 bolts then R&R shaft. If twist is located in different location a trans split would be required.

burnsg2003 · Sep 16, 2020

The twist is on the outside on the splined shift it. SO if I am understanding correctly I can unbolt it at the back an replace basically the
splined shaft. Not sure when you refer to RC what that means. Thanks

Tx Jim · Sep 16, 2020

4010 RC=rowcrop with 6 cyl engine 80 pto horsepower
4010 CUT=compact utilty tractor with 3 cyl 14 pto HP

Tx Jim · Sep 16, 2020

When installing shaft utilize loc-tite on bolt threads

burnsg2003 · Sep 16, 2020

Mine is the row crop with 6 cylinder diesel

John deere 4010

burnsg2003

Member

SVcummins

Well-known Member

Tx Jim

Well-known Member

burnsg2003

Member

Tx Jim

Well-known Member

Tx Jim

Well-known Member

burnsg2003

Member

Similar threads