MILLARD HAYES
Member
This super M is going to have a 2 wire alt. Which side of the amp gauge will the battery wire go to. Also which amp post will the kill switch connect to. It's a push pull switch
- Thread starter MILLARD HAYES
- Start date
used red MN
Well-known Member
- Location
- Coon Rapids, MN
Well I can not tell you which side of the amp gauge the
wires will go to but if you are changing over from an original
6V positive ground system the wires will be swapped to
opposite sides they were originally. I will include a wiring
diagram that will roughly apply to your needs. It is a
diagram for a Delco 10si re-wire diagram but if should give
you an idea of what you need. Disregard the solenoid and
starter button unless you have added one.
12v conversion diagram
wires will go to but if you are changing over from an original
6V positive ground system the wires will be swapped to
opposite sides they were originally. I will include a wiring
diagram that will roughly apply to your needs. It is a
diagram for a Delco 10si re-wire diagram but if should give
you an idea of what you need. Disregard the solenoid and
starter button unless you have added one.
12v conversion diagram
BarnyardEngineering
Well-known Member
- Location
- Rochester, NY
Real simple: The battery connects to one side, everything else connects to the other side.
If the ammeter reads backwards, swap everything.
If the ammeter reads backwards, swap everything.
MILLARD HAYES
Member
Thanks for the diagram
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy