1066 new ta problems

horgan farms

New User
1066 with new TA. when you try to let out on the clutch it pulls engine down. even when in neutral. I drove it about 10 minutes then stopped put in neutral and started to let off clutch and it pulls engine down. Shut it off and got off and looked at all the levers it is in neutral. pulled the tractor with a pick-up on a road to get home. it rolls fine. don't know what to check.
 
If the TA clutch and the Locking clutch are applied at the same time it will do that. My guess is that it was plumbed wrong or there is a valve not
moving correctly in the MCV system. Jim
 
I have seen new TA do that so as you start up the clutch down you let the clutch out it kill the motor but one time high capacity said that if you put that non-TA gasket in there it would do that I have had those diode TA Lock up on the low side and when you throw up to high side it would kill the engine right now because the sprague was locked up I would say you have a bad TA and it?s not the gears in the transmission And you did count the number of clutch plates in direct drive when you put the quil shaft in
 
It could be in the transmission did you try to shift gears after
you stopped because you put it in neutral and rolled it and if
you had two gears locking up in of 1 2 and one of 3 4one of
each of those gears is still in gear I bet that you miss one of
forks in slot and it locking in two gears
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top