(800) 853-2651
SHOP NOW

DC Brakes

T

The Claw

Member
Is there a speedy sleeve for a 1953 DC for the shaft that the brake discs go on (differential carriage)? Have some grooves worn in it.
 
u would have to measure the shafts then inquire about the sleeves. nothing would be specific to that tractor. plus if its not much of a groove just replace the seals. a new seal will work and that is a slow turning shaft also.
 
I am almost sure the new sleeves are narrower, and you can use two on the install. The second sleeve should land in an area not affected by corrosion or pitting.CM
<video width=90% src=https://www.yesterdaystractors.com/cvvideos/cvvideo109624.mov controls>http://



cvphoto109626.jpg




cvphoto109628.jpg
The third pic is not a DC carrier,but for demonstration purposes. Notice that I installed Two seals. Best of luck in your project .CM
 
(quoted from post at 10:13:24 12/01/21) I am almost sure the new sleeves are narrower, and you can use two on the install. The second sleeve should land in an area not affected by corrosion or pitting.CM
&lt;video width=90% src=https://www.yesterdaystractors.com/cvvideos/cvvideo109624.mov controls&gt;http://



&lt;img src=https://www.yesterdaystractors.com/cvphotos/cvphoto109626.jpg&gt;



&lt;img src=https://www.yesterdaystractors.com/cvphotos/cvphoto109628.jpg&gt; The third pic is not a DC carrier,but for demonstration purposes. Notice that I installed Two seals. Best of luck in your project .CM
Click to expand...
 
This is not a DC carrier, but you see that I was able to install two seals,as I believe you will be able to.The newer seals are not as wide as the OEM seals
cvphoto109629.jpg
 
You must log in or register to reply here.

Similar threads

E
49 DC brake hardware
Replies
5
Views
215
chuck machinist
chuck machinist
D
Ad for late model DC and SC with claimed horsepower ratings
Replies
2
Views
286
Don Rudolph
D
G
Case DC Timing
Replies
17
Views
590
rustred
rustred
B
REBUILDING POWER STEERING CONTROL VALVE ON FORD 2000
Replies
2
Views
268
ptfarmer
ptfarmer
N
DC Piston
Replies
2
Views
336
chuck machinist
chuck machinist
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top