D17 Gasser picture needed please

Sigh.....I got the head back from the shop and noticed the plates that cover the cooling ports on top of the head were gone. I didn't notice until I got home. Can someone send me a pic of an assembled head so I can show them what I am looking for? It can be complete I don't care. I should have taken a picture of the engine when I pulled it I guess. Any help would be great.
 
Back plate is roughly the same size as the hole and should have the coolant temp gauge port in it. Front one is the thermostat housing.
AaronSEIA
 

I dont think this one had the fitting for a gauge in it, just a plate.
LOL...oh ya duh on the front one.. Bwahahahahaha my bad.
 
Do you know if the engine was original to the tractor? The WD/WD45 just used a plate. The D17 with the remote mounted temp gauge always had the temp gauge port in the back cover plate. https://na.apb.agcocorp.com/p/agcoallis/79001549/l/30?keyfield=8d45159abee5a18231c1e2183d2fec94
AaronSEIA
 
The rear "plate" on a D17 should be a cast iron block. A thin steel plate was used on the WD45 and could be a pain trying to seal up, as it would warp when torqueing the head. Hopefully, as long as you're doing head work, you'll have a working thermostat in the front housing, and a working temperature gauge plumbed into the rear "block".
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top