Home | Gallery | Forums | Ads | Store ANTIQUETRACTORS.COM

AntiqueTractors.com Antique Tractor Resource Page

   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   H. Ferguson John Deere Massey Minn. Moline Oliver

Marketplace
Tractor Manuals
Tractor Parts
Engine Kits
Classified Ads
Photo Ads

Community
Discussion Forums
Collector Profiles
Show Guide
Guest Book

Galleries
Tractor Photos
Garden Tractors
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads

Research Center
Tractor Values
Production Numbers
List Prices
Tune-Up Specs
3-Point Specs
Spark Plug List
Torque Values
Torque Specs
Plow Specs
Terminology
Clubs & Pubs
JD New Generation
JD HP Chart

Miscellaneous
Today in History
Link of the Day
Pic of the Day
Table of Contents

Related Sites
Garden Tractors
The Tractor Shed
TractorLinks.com
Ford 9N/2N/8N Club
Yesterday's Tractors
Today's Tractors
Kountry Life
Classic Trucks
More Sites

YT Article

Contributed Article

Talk of the Town:
Can You Patch a Tire Sidewall?

Another great discussion from the Tractor Talk Discussion Forum.

The discussion started out with the following post:

"Has anyone attempted (or succesfully) glued or bolted a patch to the tires' sidewall. I cannot afford a tire right now but have some horse stall mat material and could buy some glue. I could use some advice on what glue I might try or if this is a stupid idea. "

What followed are some interesting replies:

" I doubt if any type of glue would be satisfactory for sidewall damage. The flexing of the sidewall would soon loosen it or tend to rupture and separate next to the solid patch. If the puncture is not too large, you may want to consider putting in a boot. A boot is simply a large piece of rubber material that lies inside of the tire along the damaged area from bead to bead. It prevents foreign material from entering the tire and eventually destroying the tube. They are not intended for large diameter punctures or for tears in a sidewall. A boot may prolong the use of the tire for awhile but if you are using it often and heavily it may not be worth the cost of dismounting and mounting the tire. Chances are it will be looking for a used tire or bucking up to buy that new one. "


" Yes, it can in most cases be fixed, it's worth a try. Give Gemplers a call. (They have an internet address I believe it is www.gemplers.com) Someone their should be able to fix you up with the correct sidewall boot to fix the tire. "

" There is a place here in Texas called tire welders. They will fix almost anything. You can try to find a place like this near you. "

" In my experience (no tractor tires yet, only truck tires knock on wood) sidewall punctures up to 1/2 inch can be fixed with a single patch while cuts and rips to about an inch can be double or triple patched. I ran a truck tire on reservation backroads and hiways for about 15,000 miles before the patch bulged. It didn't give but I gave up on the tire. The principal here used to run a tire service and sez that he has run six inch patches on tractor tires when a replacement would take a few days to arrive. He says to watch for tears along the seams or along the lugs. Practically 3/4 - 1 inch is the biggest he'd recommend. Hope this helps. "

" A Goodyear dealer in our area vulcanizes sidewalls. They grind out the rubber inside and out down to the nylon fabric several inches wider than the cut then add several layers of rubber coated nylon fabric like the plys used to build a tire. The tire is placed in a special heated press and cooked under pressure for several hours. I had a 18.4x38 with 2 cuts a 3 inch and a 4 inch cut repaired for $75. We have one tire that was patched 6 years ago and still no problem. "

This information was gathered at the Tractor Talk Discussion Board.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2020 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy